Cmos Clearing (Jp5); 2-3.5 Power On - SOYO SY-7VCA User Manual

Hardware Installation

2-3.4 CMOS Clearing (JP5)

After you have turned off your computer, clear the CMOS memory by
momentarily shorting pins 2-3 on jumper JP5, for a few seconds. Then
restore JP5 to the initial 1-2 jumper setting in order to recover and retain
the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Short pin 2-3 for
JP5 Setting at least 5 seconds to
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

2-3.5 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Clear CMOS Data
43
Retain CMOS Data
Short pin 1-2
to retain new
settings
1 2 3
SY-7VCA
1 2 3