4
REGISTERING
To use the Magic Remote Control, pair it with
your TV first.
How to register the Magic
Remote Control
1 Put batteries into the Magic Remote
Control and turn the TV on.
2 Point the Magic Remote Control at
your TV and press the WHEEL (OK)
on the remote control.
* If the TV fails to register the Magic
Remote Control, try again after
turning the TV off and back on.
How to Re-register the Magic
Remote Control
Press the BACK
the same time, for five seconds, to
unpair the Magic Remote Control
with your TV.
If you wish to re-register the remote,
press the WHEEL (OK) on the remote
control.
HOW TO USE
and SMART
at
/Q.MENU
* Shake the Magic Remote Control slightly to the right
* Shake the Magic Remote Control slightly to the right
* If the pointer has not been used for a certain period of
* The wheel also functions as the 'OK' button when
* You can change channels and scroll through menus
* You can just move your wrist to move the pointer
* The Magic Remote Control depletes batteries faster
* If the pointer loses its calibration, set down the remote
and left or press SMART , ,
the pointer appear on the screen.
and left to make the pointer appear on the center of
screen.
time, it will disappear.
pressed.
using the Wheel.
instead of moving your whole arm.
than a normal remote due to the additional features.
You may wish to use rechargeable batteries.
for a couple of minutes to let it recalibrate.
buttons to make
/Q.MENU
Need help?
Do you have a question about the AN-MR400 and is the answer not in the manual?