Control Panel; Rear Terminals - Panasonic PT-VW430U Operating Instructions Manual

Control panel

(1)
(2)
(3)
(4)
(5)
(6) (7) (8)
(1) < > button
Turn the projector on/off.
(2) <ON(G)/STANDBY(R)> indicator
Indicate the power status.
(3) <LAMP> indicator
Light yellow when the projection lamp reaches its
end of life.

Rear terminals

(1)
(5)
(6)
(1) COMPUTER 1 IN/ COMPONENT IN
Connect to COMPUTER 1 IN/ COMPONENT IN
input signals.
(2) COMPUTER 2 IN/ MONITOR OUT
Connect to COMPUTER 2 IN/ MONITOR OUT
input signals or outputs the analog RGB signals
input the projector.
(3) HDMI IN
Connect to HDMI input signals.
(4) LAN
Connect to a LAN cable for network connection.
(5) Security slot
Attach the commercial shackle lock, manufactured
by Kensington, to protect your projector.
Compatible with the Kensington MicroSaver
Security System.
(6) SERIAL IN
Connect to a computer via an RS-232C cable.
(4) <WARNING> indicator
(9)
(5) Daylight view sensor
(6) <MENU> button
(7) <ENTER> button
(10)
(8) ▲▼◄► buttons
(9) <INPUT> button
(10) <AUTO SETUP> button
(2)
(7) (9)
(8)
(7) VIDEO IN
(8) AUDIO IN
(9) COMPUTER AUDIO IN 1
(10) COMPUTER AUDIO IN 2 (MIC IN)
(11) VARIABLE AUDIO OUT
(12) S-VIDEO IN
Attention
z
About Your Projector
Indicate the abnormal conditions of the projector.
Detect room's light.
Display the MENU screen. (
Execute the selected item.
Navigate the MENU screen.
Adjust the volume level or mute the sound.
Select the input signal. (
Æ
Execute the setting of Auto setup in the setting
menu.
(3)
(10) (11)
Connect to VIDEO input signals.
Connect to the audio input signals.
AUDIO IN has left and right (L and R) terminals.
Connect to the audio input signals.
Connect to the audio input signals. Or connect
the MIC to this jack.
Output the audio signals input to the projector.
Connect to S-VIDEO input signals.
When a LAN cable is directly connected to the projector,
the network connection must be made indoors.
page 36)
Æ
page 32)
(4)
(12)
ENGLISH -
19