Recommended Accessories - Sears Craftsman 113.244420 Owner's Manual

ntenance
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER OUTLET BEFORE MAiNTAiNiNG OR
LUBRICATING YOUR BAND SAW.
TIRES
Pitch and sawdust that accumulate on the tires should
be removed witha stiff brush or scraped off with a
piece of wood. Do not use a sharp knife or any kind of
solvent.
When the tires become worn they should be replaced.
When replacing the tires, stretch them around the
wheels but do not glue them on.
GENERAL
Keep your Band Saw clean,
Remove sawdust from the inside.
Do not allow pitch to accumulate on the table, blade in-
sert, blade guides, or tl_rust rollers. Clean them with
Craftsman Gum and Pitch Remover,
Apply a thin coat of autornobile-Wpe wax on the table
so the wood slides easily while cutting. Also apply wax
to the inside surfaces of the trunnion.
MOTOR
Frequently vacuum or blow out any sawdust from the
motor.
If the power cord is worn, cut, or damaged in any way,
have it replaced immediately.
LU BRICATION
All of the BALL BEARINGS are packed with grease at
the factory. They require no further lubrication.
BLACK
m MOTOR
RECOMMENDED ACCESSORIES
Item Cat. No.
Floor Base................................ 9-22213
Miter Gauge.......................... 9-22574
Rip Fence................................ 9-23433
Blades................................ See Catalog
Steel Leg Set. ............................ 9-22236
Circle Cutting Attachment ................... 9-24301
Table Extension ........................... 9-24302
Power Tool Know How Handbooks
Radial Saw ................................ 9`2917
Table Saw................................. 9-2918
The above recommended accessories are current
and were available at the time this manual was
printed.
18