4) Securely tightenthe screw,
NOTE: T HENEXT TWOSTEPS ARE PRE-ASSEMBLY
STEPS.
5) Sgde theretainerovertheendof thepivotshaftfor about2".Theretainer m ayfit tightly; thisis normal
6) Threadthe#1_`16x1/2"_ngpanheadtappingscrewint_theh_eintheretainerunti_itbott_ms-_tagain_tthepiv_tsha_.(Thescrew
will fit tightlyin the hole.) SeeFigure 10.
Fig. 10
_
#!0-16X 1/2"LONG PANHEAD TAPPING
SCREW
7) Loosenthescrewaboutone turn. Remove the retainer f rom the shaftandsetit asidetemporarily.
8) Assemble the pivot shaftwith camhandle to the basebyinsertingtheendof thepivot shaftthroughthe holestnthe righttemplate
support andthebase.
9) MAKESURE THEORIENTATION
OFTHECAMHANDLE ISAS SHOWN IN FIGURE 11.
10) Placethe retainerat thelocationshownin Figure12 end pushthe pivotshaftthrough.THEORIENTATION
OFTHERETAINER RELAT]VE
TOTHECAMHANDLE WITHSCREW MUSTBEAS SHOWN.
NOTE: T HERETAINER M AY FITTIGHTLY ONTHEPIVOT SHAFT; THISIS NORMAL.
Fig. 11
DOVETAIL
BASE