Sears Craftsman 171.25450 Owner's Manual page 12

•Placethetemplatestiffenerinto therectangular s lot in the underneath s ideof thetemplate, a sshownin Figure 18.
NOTE: T HETEMPLATE FORCUTTING HALF-BLIND J OINTS ISBEING USED ASANILLUSTRATION INTHEFOLLOWIHG FIGURES.
1) Threada #8-36x 3/16"long panhead machine screwthrougheachof the fiveholesin thetemplateandinto thethreaded holesin the
templatesupport,asshownin Figure24 and securely tightenall of thescrews.
Fig. 18 _ TEMPLATE STIFFENER
\ _ _ _ J jRECTANGULARSLOT
TEMPLATE
_ _ MACHINESCREwSLOTTED BINDING H EAD_ _ MA#&3gX3!!6"t°ngPANHEADcHINE SCREW
NOTE: O NSOME EARLY V ERSIONS O FTHISPRODUCT, A SLOTTED B INDING HEAD MACHINE SCREW HASBEEN SUBSTITUTED FOR THE
PANHEAD S CREW SPECIFIED F ORASSEMBLING THETEMPLATE SUPPORTS T OTHE TEMPLATES. (SEE THESCREW ILLUSTRATION IN
FIGURE 18),
2) Assemble thetemplatebrackets to thetemplateusingfour #10-32x 3/8°longpanhead machine screws_ as shownin Figure19.
3) MAKESURE THAT THE TEMPLATE B RACKETS ARE ASSEMBLED TOTHEUNDERNEATH SIDEOFTHETEMPLATE, AS SHOWN IN
FIGURE 19,ANDTHAT THE AL]GNMENT O FTHEBRACKETS IS ALSO ASSHOWN IN THEFIGURE.
4) IT IS NOTNECESSARY FOR THESCREWS T OBETIGHTENED ATTHISSTAGE; THETEMPLATE B RACKETS S HOULD BEFREE TOMOVE
WITHRESPECT TOTHETEMPLATE O RELSE ITWILL NOTBEPOSSIBLE T OALIGN THETEMPLATE A S DESCRIBED INTHENEXT SECTION.
5) Theassembled templateshouldlookliketheillustrationin Figure20.
Fig. 19
#10-32 X 3/8"tongPANHEAD MACHINE SCREW
TEMPLATE
'\
_- TEMPLATE BRACKET ....
6) Assemble thetemplatestiffener andthetemplatebrackets to the TEMPLATE F OR CUTTING THROUGH JOINTS usingthesamemethod
described in the preceding steps1 through5, Refer to Figure20.
Fig. 20
lg