Product Specifications - Craftsman Nextec 320.74906 Operator's Manual

of moving parts, binding of moving parts, breakage of parts, mounting, and
any other condition that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced by an authorized service
center unless indicated elsewhere in this manual.
= Do not charge appliance in rain, or in wet locations.
= Do not use battery-operated appliance in rain.
= Do not attempt to remove cut material nor hold material to be cut when
cutting flails are moving. Make sure that the trimmer switch is off when
clearing jammed material from cutting flails. Do not grasp the exposed cutting
cutting flails or cutting edges when picking up or holding the hedge trimmer.
CAUTION: cutting flails coast after turning off.
CAUTION: Do not attempt to operate this tool until you have read all
instructions, safety rules, and warnings thoroughly. Failure to comply may result
in fire, electric shock, or serious personal injury. Keep the Owner's Manual for
future reference, and review it frequently.
= Remove or disconnect battery before servicing, cleaning or removing
material from the gardening appliances.
Use only the battery and charger listed:
BATTERY PACK CHARGER
320.10006
320.11221
320.14300
= Do not dispose of the battery (ies) in a fire. The cell may explode. Check
with local codes for possible special disposal instructions.
• Do not open or mutilate the battery (ies). Released electrolyte is corrosive
and may cause damage to the eyes or skin. It may be toxic if swallowed.
Exercise care in handling batteries in order not to short the battery with
conducting materials such as rings, bracelets and keys. The battery or
conductor may overheat and cause burns.
• Keep guards in place and in working order.
= Keep cutting flails sharp.
= Keep hands and feet away from cutting area.
= Keep your hands away from the cutting flails.
KNOW YOUR HEDGE TRIMMER (Fig. 1)
Fig. 1
Lock-off button
Cutting flail
Battery pack
Trigger switch
Auxiliary Handle
• y handle
locking lever
Telesco '
pole locking
lever
I-elescoping pole
Cutting flails
Wire edge
guide
uard
PRODUCT SPECIFICATIONS
Motor Type 12.0 Volt DC
Head Rotation Positions 0 °, 60°and 90 °
Cutting capacity 9" diameter
Speed (no Load) 8000 RPM
Telescope adjustment 13-inch.
Cutting system Plastic Cutting Flails
Battery Type Lithium-Ion
Charger Input 120-Volts, 60 Hz AC only
Optimum Charging Temperature 32°F (0 ° C) -104°F (40°C)
Weight (without battery) 3.5 Ibs
74906 ManuaLRevised_11 0210 Page 7 74906 ManuaLRevised_11 0210 Page 6