Table of Contents
Advertisement
_ib
ARNING:
Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
_i
ARNING:
Do not allow familiarity with your
drill-driver to make you careless. Remember that
a careless fraction of a second is sufficient to
inflict severe injury.
CHARGING
YOUR
DRILL-DRIVER
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it until light on front of
charger changes from red to green.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
•
Charge battery pack only with the charger
provided.
•
Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charger aligning raised rib in
charger with groove in battery pack.
•
Press down on battery pack to be sure contacts on
battery pack engage properly with charger
contacts.
•
Red light should turn on. Red light indicates fast
charging mode.
If red light is flashing, this indicates battery pack is
deeply discharged or hot.
If battery pack is hot, red light should become
steady after battery pack has cooled down.
If battery pack is deeply discharged, red light
should become steady after voltage has increased,
normally within 30 minutes.
If after one hour red light is still flashing, this
indicates a defective battery pack and should be
replaced.
Green light on indicates battery pack is in slow
charging mode or fully charged.
Yellow light on and red light flashing indicates
defective battery pack. Return battery pack to your
nearest Sears Repair Center for checking or
replacing.
•
When your battery pack becomes fully charged, the
red light will turn OFF and the green light will turn
ON.
•
If you remove battery pack from charger and
reinsert it immediately (less than 5 seconds)
back in charger, the green light will come on
indicating full charge and slow charging mode
until removed from charger. If you remove
battery pack from charger and wait more than 5
seconds before reinserting it back in charger,
the charger will function normally.
•
After normal usage, 1 hour of charging time is
required to be fully charged. A minimum charge
time of 1-1/2 hours is required to recharge a
completely discharged tool.
•
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
•
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
,_
CAUTION:
Your drill-driver's battery pack
contains special high temperature batteries to
help prevent battery damage when left on charge
for extended periods of time. However, once the
batteries become fully charged, we recommend
that you unplug your charger from power supply
and remove the battery pack.
LED FUNCTION
OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
1.
Red LED Lighted = Fast Charging Mode.
2.
Green LED Lighted = Slow Charging Mode and Fully Charged Battery Pack.
3.
Red LED Flashing = Hot or Deeply Discharged Battery Pack. Also Defective
Battery Pack After I Hour.
4.
Yellow LED Lighted and Red LED Flashing = Defective Battery Pack.
7
Advertisement
Table of Contents
