Craftsman 580.762202 Operator's Manual page 5

Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun. Tighten by
hand,
o
o
Place assembled spray gun on holder.
Place turbo nozzle in grommet hole in base.
Remove plastic cap and connect high pressure
hose to pump, Tighten by hand,
Attach High
Pressure
hose here
Attach nozzle extension to spray gun.
Attach adjustable nozzle to the nozzle extension.
CHECKLIST
Before you operate your new high pressure washer
please review the following checklist:
o All assembly instructions have been completed.
, The high pressure hose connections to the spray
gun and to the pump are tight and secure,
While learning how to use your high pressure
washer, pay extra attention to the following important
item:
Engine oil is at proper level
important: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure. See
Page 9 for instructions on adding oil and proper oil
specifications.
Important: The water supply to your pressure washer
must be connected and turned on prior to starting your
engine.
Be sure gas tank is properly filled with clean, fresh,
unleaded gasoline.
Become familiar with all controls - their location
and function. Operate those controls before starting
the engine.
5