i
,....,, .,,
i
.,..,,.,, i.
SERVICE AND ADJUSTMENTS
TRANSAXLE
SHIFTER
LINKAGE
AND AD-
JUSTMENT
(See Figs. 35 and 36)
The transaxle shouldbe in neutral when the gearshift lever
is in the neutral (lock gate) position. The adjustment is
preset at the factory; however, if adjustment is needed,
proceed as follows:
•
Make sure transaxle is in neutral.
•
Loosen two Iocknuts on tie rod.
•
Turn center rod until gearshift lever falls into neutral
lock gate on fender console.
•
Tighten Iocknuts securely.
_GEARSHIFTLEVER
NEUTRAL
LOCK GATE,
FIG. 35
_
_KNUTS
TO ADJUST STEERING
WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor.
If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center.
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 37)
•
Block up axle securely.
•
Removeaxlecover, retaining ring andwashersto allow
wheel removal (rear wheel contains a square key - Do
not lose).
•
Repair tire and reassemble.
•
On rear whee]s only: align grooves in rear wheel hub
and axle. Insert square key.
•
Replace washers and snap retaining ring securely in
axle groove.
•
Replace axle cover.
WASHERS
RETAINING
RING
AXLE
COVER
SQUARE KEY (REAR WHEELS ONLY)
FIG. 36
FIG. 37
23