Epson A881391 User Manual page 2

This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
user is encouraged to try to correct the interference
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
(1) Any changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to
(2) Shielded interface cables and AC power cord must be used in order to comply with the
emission limits.
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the radio interference regulations of the Canadian
Department of communications.
Le présent appareil
applicables aux appareils numériques de Classe B prescrites dans le réglement sur le
brouillage radioélectrique édicté par le Ministére des Communications du Canada.
FCC COMPLIANCE STATEMENT
FOR AMERICAN USERS
no guarantee
FOR CANADIAN USERS
n'éme-t pas
numérique
that interference will not occur in a
by or more of the following
one
NOTICE
operate the
bruits radioélectriques dépassant les limites
de
This
installation.
and on, the
equipment