CUSTOMER RESPONSIB LRT ES
LUBRICATION
ENGINE OIL RECOMMENDATIONS
A 20 ounce bottle of SAE 30 oil is included with your
new lawn mower
Only use high quality detergent oil rated with API ser-
vice classification
SG. Select the oil's viscosity grade
according to your expected operating temperature.
Colder -,_
32°F
_=- Warmer
5W30
[]
SAE 30
NOTE: Although
multi-viscosity
oil (5E30, 10W30,
etc.) improves starting in cold weather, these multi-
viscosity oils will result in increased oil consumption
when used above 32 ° F_ Check your oil level more
frequently to avoid possible engine damage from run-
ning low on oil
WHEELS
DO NOT oil or grease the wheel bearings_ Viscous
lubricants will attract dust and dirt that will shorten the
life of the self-lubricating
wheel bearings.
If you feel
the wheels must be lubricated, use only a dry, silicone
type lubricant sparingly_
WHEEL ADJUSTERS
For easy operation,
lubricate the wheel adjusters
at
least once a season with light oil.
BRAKE SPRING BRACKET
Spray a light oil lubricant on the brake spring bracket,
located on the right rear corner of the engine, at least
once a season.
TRANSMISSION
The transmission
is pre-lubricated
and sealed at the
factory. It does not require checking. If disassembled
for any reason, fill with 2 ounces of Alvania grease,
part number 737-0168.
e Use a block of wood between
blade and mower
deck to prevent blade from turning when bolt is
removed.
Protect your hands with gloves and/or
wrap blade with heavy cloth
Remove
blade bolt by turning
counterclockwise
Use a 9/16" box or open-end wrench
TO REPLACE BLADE (See Figure 11):
e Put blade adapter on engine crankshaft
e Fit blade in adapter. Be sure trailing edge of blade
is up towards engine.
e Assemble
bolts, washers,
and nuts in the exact
order of removal.
Q
Use block of wood to hold blade and tighten bolt
clockwise. The recommended
torque for the center
is 450-600 in. Ibs. The recommended
torque for the
blade
adapter
bolts is 200-350
in. IbsTorque
wrenches
are available at most Sears stores and
through the catalog.
IMPORTANT:
THE BOLT USED TO SECURE
THE
BLADE TO ENGINE IS SPECIALLY HEAT-TREATED.
DO NOT SUBSTITUTE (SEE REPAIR PARTS).
CAUTION:
A LOOSE
BLADE
CAN
BE
DANGEROUS
AND
MAY
MAKE
THE
ENGINE HARD TO START,
Use only a Sears authorized replacement blade to get
the best cutting results.
Nut--
Adapter--_
Blade Adapter___.._
.._..-Lock
Washer
asher
_<L_Center
Bolt
MOWER
BLADE CARE
Your mower will work better with a sharp blade_
FIGURE 11.
NOTE:
We do not recommend
sharpening
the
blade--but
if you do, be sure blade is balanced.
CAUTION:
DISCONNECT
SPARK
PLUG
WIRE FROM SPARK PLUG AND PLACE
WIRE WHERE IT CANNOT COME IN CON-
TACT WITH THE SPARK PLUG,
TO SHARPEN BLADE
• The blade can be sharpened
with a file or on a
grinding wheel. Do not attempt to sharpen while on
the mower.
TO REMOVE BLADE (See Figure 11):
e Turn mower on its side. Make sure air filter and
carburetor are up.
e Care should be taken to keep the blade balanced.
An unbalanced blade will cause excessive vibration
when running and eventual damage to mower and
engine
10