Replacing T Heline - Craftsman Weedwacker 358.796050 Operator's Manual

REPLACING T HELINE
• Push and hold the engine stop switch
in the stop/offposition unti!the unithas
fuUy stopped,
• Discenect the spark plug wire.
• Remove the spool by firmly pulling
on the tap button.
• Clean entire surface of hub and
spool.
• Replace with a pro-wound spool, or
cut a length of 20 feet of .065" (1.6
ram) diameter Craftsman ® Pro Trim-
tamer line. Never use wire, rope,
stdng, etc., which can break off and
become a dangerous missile.
• Insert one end of the line about 112
inch (1 cm) into the small hole inside
the spool
• Wind the line evenly and tightly onto
the spool, Wind in the direction of the
arrow found on the spool.
° Push the line into the notch, leaving
3 to 5 inches (7 - 12 cm) unwound.
• Insert the line into the exit hole in the
hub as shown in the illustration.
• Align the notch with the line ex'r_ hole.
• Push the spool into the hub until it
snaps into place.
• Pullthe line extending.qutside the hub
to release it from the notch.
"_-- Spoor
Linein _ .._----------__-_ J
Lineexit hole
CARBURETOR ADJUSTMENT
WARNING: The trimmer head will be
spinning dudng most of this procedure.
Wear your protective equipment and
observe all safety precautions. After
making mixture adjustments, recheck
idle speed.
Carburetor adjustment is critical and if
done improperly can permanently
damage the engine as well as the car-
buretor. If you require further assis-
tance or are unsure about performing
this procedure, call our customer as-
sistance help line at 1-800-235-5878.
Old fuel, a dirty air filter, a dirtyfuel fil-
ter, or flooding may give the impres-
sion of an impmpedy adjusted carbu-
retor.Check these conditions before
adjusting the carburetor.
The carburetor has been carefully set
at the factory. Adjustments may be
necessary if you notice any of the fol-
lowing conditions:
• Engine will not idle. See "Idle Speed"
under adjusting procedure.
• Engine dies or hesitates instead of
accelerating. See "Acceleration
Check" under adjusting procedure.
, Loss of cutting power. See "Mixture
Adjustment" under adjusting
procedure.
There are two adjustment screws on
the carburetor.
CARBURETOR PRESETS
When making carburetor preset adjust-
ments, do not force plastic limiter caps
beyond stops or damage will occur.
tf carburetor presets are not needed,
proceed to "Adjusting Procedure, Idle
Speed."
To adjust presets:
• Turn mixture screw counterclockwise
until it stops.
• Tqrn the idle speed screw clockwise
uqtil it stops. Now turn counterclock-
wise 4-1/2 turns.
, Start motor, cut grass for 3 minutes,
aqd proceed to the adjustment
section. If engine does notstart,
10