Advertisement
Available languages
Available languages
Call 1-800-4MY-HOME
(1-800-469-4663)
for Service Parts
Refer to Service Parts Drawing for full listing of Service Parts
HARDWARE:
(4) 14-10 X 3/4 Screw
(16) 1/4-20 X 518 Screw
(16) 114" Nut
SIDE HANDLE
ATTACHMENT:
• Attach the side handle using (4) 14-10 x
3/4 screws. Do not over tighten screws.
CASTER
INSTALLATION:
NOTE: Use adequate manpower for this
operation.
• Remove the bottom drawer by following
the drawer removal instructions.
• Lay the cabinet down on its back. Use
packaging material to protect the paint
finish.
• Mount both swivel casters on the same
side of the cart.
114"Nut
J
1/4-20 X 5/8"
Screw
• Attach each caster using (4) 1/4-20 x 5/8
screws and (4) 1/4" nuts per caster.
• Wrench tighten all screws.
• Return the cart to its upright position.
REMOVING AND INSTALLING
D RAWE RS:
•
Empty the drawer.
•
Fully extend the drawer.
Release
Right
•
Lever Style - Lift or lower (depending
on the slide) the release lever on both
sides, (this allows the slides to ride
over the stops). Pull out to remove.
Tab Style - Depress the release tabs
on both sides, (this allows the slides
to ride over the stops). Pull out to
remove.
•
To reinstall, push the drawer into the
unit until the drawer stops.
REMOVING AND INSTALLING
SLIDES:
NOTE: To remove the slide from the
unit, first remove the drawer.
•
Lift and hold the spring retainer, and
push the slide toward the rear of the
unit. The slide may now be removed.
J
\\
\ \
/
\
\
Spring
\_\
Retainer
To reinstall the slide, place the slide in
the appropriate position in the unit and
pull toward the front of the unit until the
spring retainer snaps into position and
secures the slide.
•
For casters, use high quality bearing
grease, (yearly).
•
Lubricate the slides, (twice yearly).
•
Lubricate lock with graphite, (yearly).
•
Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and
water.
•
Auto wax wilt preserve the storage
unit's luster finish. Apply the wax as to
a car. The wax will also help protect the
unit against scratches.
•
Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable
cleaning
fluid.
•
If drawer liners are supplied, it is
recommended
they are used to protect
the finish inside the drawers and to
make the drawers easier to clean. The
drawer liners may be cleaned with
soap and water.
3
4
Advertisement
