Craftsman 580.752610 Operator's Manual page 13

2600 psi max 2.3 gpm max
Hide thumbs Also See for 580.752610:
Table of Contents

Advertisement

Available languages

Available languages

How to Stop Your Pressure Washer
1.
Releasespray gun trigger and let engine idle for two
minutes.
2.
Move engine stop switch to "Off" position.
3.
ALWAYS point spray gun in a safe direction, push red
button and squeezespray gun trigger to releaseretained
high water pressure.
IMPORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
A. WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, spray tip extension and quick connect
spray tips. There is also a detachable hose wrap at the back
of the accessory tray to hold your high pressure hose.
1.
Place spray tip extension in clip on back of accessory
tray.
2.
Place spray gun through hole on accessory tray on right
side of unit.
3.
Insert multi-colored spray tips in spaces provided in
accessory tray.
4.
Wrap high pressure hose on hose wrap then attach hose
wrap to back of accessory tray.
5.
Hook provided on back of accessory tray for safely
storing safety goggles.
How to Use Spray Tips
The quick-connect on the spray tip extension allows you to
switch between four different quick connect spray tips. The
spray tips vary the spray pattern as shown below.
Low Pressure
Black
Use to apply
chemical
m
i
r_
40° White
2600 PSI
2.3 GPM
High Pressure
15° Yellow
0° Red
2600 PSI
2600 PSI
2.3 GPM
2.3 GPM
Follow these instructionsto changespray tips:
1.
Pull back collar on quick-connect and pull current spray
tip off. Store spray tips in holder provided on the
accessory tray.
A. WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER exchange spraytips withoutthetriggerlockedon the
spraygun.
• DONOT twist spraytips whilespraying.
.
Select desired spray tip:
For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select yellow
15° spray tip.
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
13

Advertisement

Table of Contents
loading

Table of Contents