Table of Contents
Advertisement
USING THE WOODWORKmNG
SUB-BASE
WroTH HANDLES
The woodworking
sub-base with handles is convenient
when routing 4 in. (101.6 mm), 5 in. (127 mm), or 6 in.
(152.4 mm) circular grooves. Htcan also be used when
routing grooves parallel to the edge of the workpiece.
The handles allow you to grasp and hold the trimmer with
two hands, similar to grasping and holding a router.
ROUTmNG GROOVES
mNA CmRCLE
See Figure 12.
[] There are three holes marked R2", R2-1/2", and R3"
on the sub-base.
Each number represents a radius and
may be used when cutting circular grooves that are 4
in. (101.6 mm), 5 in. (127 mm) or 6 in. (152.4 mm) in
diameter.
[] Select the radius for the desired circle, place a finish-
ing nail through the hole and securely tack it into the
workpiece. This will create a pivot axis for that size
radius.
[] Rout a circular groove in a clockwise direction only.
See the arrow in figure 12.
ROUTCIRCULARGROOVE CLOCKWISE
FINISHING
NAIL
WORKPIECE
Fig. 12
16
Advertisement
Table of Contents
