ProForm XP crosswalk 580 User Manual page 12

14. Carefully lower the Uprights (77, 92) as shown.
Start the two indicated #8 x 1 1/2" Screws (3)
into the Left and Right Uprights (77, 92) and the
console assembly. If necessary, pull back on the
console assembly slightly to align the holes in
the Uprights with those on the console assem-
bly. Start the other two #8 x 1 1/2" Screws (3)
and then tighten all four Screws; do not
overtighten the Screws. Then, raise the
Uprights (77, 92).
See steps 4 and 6. Firmly tighten the four 3/8" x
4" Bolts (8).
14
Console Assembly
Start First
3
77
15. Remove the Resistance Knob (88) from a resis-
tance assembly. Make sure that the 3/8" x 4
3/4" Bolt (90) stays inside the resistance as-
sembly and that the resistance assembly
does not come apart. Note: See the lower
drawing to reassemble the resistance assembly
if necessary.
Apply a small amount of the included grease
around the Resistance Cone (85). Insert the
Resistance Cone into the Upright Insert (84) in
the Left Upright (77), with the two large holes on
top as shown. Then, tighten the Resistance
Knob (88) onto the 3/8" x 4 3/4" Bolt (90).
Attach the other resistance assembly to the
Right Upright (92) in the same way.
15
Grease
\
88
85
84 Large
Holes
90
12