ProForm J6si User Manual page 7

,
,
,
While a second person holds the Right Handrail (85) and
the Console Base (87) near the right Upright (82), cut the
indicated plastic ties off the Right Handrail. Do not cut
the other plastic tie off the Right Handrail. Next, cut
the plastic tie off the Upright Wire Harness (34) in the
right Upright (82). Do not drop the Upright Wire
Harness into the right Upright.
Refer to the inset drawing. Connect the Upright Wire
Harness (34) to the Console Wire Harness (48). The
latch on the Console Wire Harness should snap onto the
Upright Wire Harness. If the Wire Harnesses do not fit
together easily, turn them; do not force the Wire
Harnesses together.
Next, connect the Right Pulse Wire (121), the Left Pulse
Wire (120) and the ground wire to the corresponding
connectors on the Console Wire Harness (48); make
sure that the Wires with tags are connected to each
other.
Note that there is still a plastic tie in the Right
Handrail (85); do not remove this plastic tie.
Set the left side of the Console Base (87) on the Left
Handrail (74). Insert as much of the wires as possi-
ble into the Right Handrail (85) and down into the
right Upright (82).
Next, set the right side of the Console Base (87) on the
Right Handrail (85). Insert all excess Console Wire
Harness (48) into the Right Handrail.
Position the Right Handrail (85) on the right Upright (82)
as shown; be careful not to damage the wires. The
bracket on the base of the right Upright should be inside
of the lower end of the right Handrail, as shown in the
inset drawing.
Thread two Handrail Bolts (78) with Washers (36) into the
Left Handrail (74) and the left Upright (82) as shown. Do
not tighten the Handrail Bolts yet. Next, thread two
Handrail Bolts (78) with Washers (36) into the Right
Handrail (85) and the right Upright (82). Do not tighten
the Handrail Bolts yet. Be careful to avoid damaging
the wires.
36
36
78
Do not
121 120 Ground
85
Cut Plastic Tie
Do not
Remove
87 Plastic Tie
82
87
Bracket