Craftsman 917.387101 Operator's Manual page 7

"HARDTOP"GRASSCATCHER
ASSEMBLE FRAME AND BAG
• Thread upper tubular frame into hem of
bag as shown. Be sure angled ends of
frame point downwards.
• Slip lower frame into tubular upper
frame as shown.
• Slip vinyl bindings over frame.
• Install two (2) blunt pointed screws in
front holes and tighten securely.
Sharp pointed screws
(Rear and side holes)
Catcher top
Hem /
Start here j
Uppe
Upper tubular
frame
Vinyl bindings
Lower frame
ASSEMBLE TOP TO FRAME AND BAG
NOTE: For ease of assembly, place
catcher top upside down on work surface.
• Nest bag and frame assembly into
catcher top.
• Install two (2) sharp pointed screws into
rear holes first and tighten securely.
• Pull catcher bag forward on frame to
remove slack.
• Install two (2) remaining sharp pointed
screws in side holes and tighten
securely.
• Align lower frame and catcher top front
holes.
Blunt pointed screws
Catcher bag and {rame (Front holes)
TO ATTACH HARD TOP CATCHER
• Open the rear door on mower housing.
• Place frame side hooks into slots in
handle brackets.
• Release rear door, allowing it to nest
into top of catcher.
Rear door
slots
Grass catcher _"
frame hook
_,CAUTION: Under normal usage, the
catcher matedal is subject to deterioration
and wear and should, therefore, be
checked frequently for replacement. Any
replacement catcher should be checked to
ensure compliance with original
manufacturer's specifications.
_CAUTION: Do not run lawn mower
without the discharge guard (rear door),
approved grass catcher, clipping deflector
or mulcher plate in place. Never attempt
to operate mower with the discharge
guard (rear door) removed or propped
open.
7