Advertisement
The cutting height range is approximately
1-1/2" to 4-1/2". The heights are mea-
sured from the ground to the blade tip with
the engine not running. These heights
are approximate and may vary depending
upon soil conditions, height of grass and
types of grass being mowed.
• The average lawn should be cut to
approximately
2-1/2 inches during the
cool season and to over 3 inches during
hot months. For healthier and better
looking lawns, mow often and after
moderate growth.
• For best cutting performance,
grass over
6 inches in height should be mowed
twice. Make the first cut relatively high;
the second to desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels
are properly adjusted
when they are slightly off the ground when
mower is at the desired cutting height in
operating position. Gauge wheels then
keep the deck in proper position to help
prevent scalping in most terrain conditions.
NOTE: Be sure tractor is on a flat level
surface.
1. Lower mower and adjust mower to de-
sired cutting height(See "TO ADJUST
MOWER CUTTING HEIGHT' in this
section of manual).
2. Remove retainer spring and clevis pin
which secure each gauge wheel bar.
3. Lower gauge wheels to ground. Raise
gauge wheels slightly to align holes
in bracket and gauge wheel bar and
insert clevis pin. Gauge wheels should
be slightly off the ground.
4. Replace retainer spring into clevis pin.
5. Be sure all gauge wheels are in the
same setting.
IMPORTANT:
Be sure to readjust gauge
wheels if you change the cutting height
of the mower deck.
Retainer
Clevis
Pin
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine.You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating
or cutting off when operating your equip-
ment on rough, rolling terrain or hills.
1. Select desired height of cut.
2. Lower mower with attachment
lift con-
trol.
3. Start mower blades by engaging at-
tachment clutch control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
A
_IuLCAUTION:
Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the deflector
shield in place.
Attachment Lift Lever
_ttatCchmpe_ClL_tCTh High Positio/on
Low
"Enga_
_/
9"_/Position
__
!_,'_"_
Deflector
Shiele
"D,sengage"
__
TO OPERATE
ON HILLS
=t'_WARNING:
Do not drive up or down
hills with slopes
greater than 15 ° and do
not drive across any slope. Use the slope
guide at the back of this manual.
• Choose
the slowest
speed
before starting
up or down
hills.
• Avoid
stopping
or changing
speed
on
hills.
• If slowing is necessary,
move throttle control
lever to slower
position.
• If stopping
is absolutely
necessary,
push
clutch/brake
pedal quickly to brake position
and engage
parking
brake.
• Move gearshift
lever to 1st gear and range
shift lever to low (L) position.
Be sure you
have allowed
room for tractor to roll slightly
as you restart
movement.
• To restart
movement,
slowly release
park-
ing brake and clutch/brake
pedal.
• Make all turns slowly.
12
Advertisement
