Table of Contents
Advertisement
Replacing the shield
After you have installed options on the printer system board, follow these steps to reattach the shield and close the doors.
1
Align the slots at the top of the access cover with the screws near the top of the printer.
2
Slide the cover up under the top cover lip as far as it will go.
3
Insert and tighten the screws at the top of the cover.
4
Insert and tighten the screws at the bottom of the cover.
Installing and removing options
Replacing the shield
77
Advertisement
Table of Contents
Need help?
Do you have a question about the Multifunction Laser and is the answer not in the manual?
Questions and answers