Table of Contents
Advertisement
SERVICE
[]
[] Tool service must be performed only by qualified
repair personnel.
Service or maintenance performed
by unqualified personnel may result in a risk of injury.
When servicing
a tool, use only identical
replacement
parts. Follow instructions in the
Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance
Instructions may create a risk of shock or injury.
[] Hold tool by insulated gripping
surfaces
when
performing
an operation
where the cutting
tool
may contact
hidden wiring
or its own cord. Contact
with a "live" wire will make exposed metal parts of the
cutting tool "live" and shock the operator.
[] Know your power tool. Read operator's
manual
carefully.
Learn its applications
and limitations, as
well as the specific
potential
hazards related to this
tool. Following this rule will reduce the risk of electric
shock, fire, or serious injury.
[] Always wear safety glasses. Everyday eyeglasses
have only impact-resistant
lenses; they are NOT
safety glasses. Following this rule will reduce the risk
of serious personal injury.
[] Protect your lungs. Wear a face or dust mask if the
operation
is dusty. Following this rule will reduce the
risk of serious personal injury.
[] Protect your hearing. Wear hearing protection
during extended
periods of operation.
Following this
rule will reduce the risk of serious personal injury.
[] Inspect tool cords periodically
and, if damaged,
have repaired at your nearest Sears or other
qualified
service center. Constantly
stay aware of
cord location.
Following this rule will reduce the risk of
electric shock or fire.
[] Check damaged
parts. Before further use of the
tool, a guard or other part that is damaged
should
be carefully
checked
to determine
that it will
operate properly
and perform
its intended function.
Check for alignment
of moving parts, binding of
moving parts, breakage
of parts, mounting,
and
any other conditions
that may affect its operation.
A guard or other part that is damaged
should be
properly
repaired
or replaced
by an authorized
service
center. Following this rule will reduce the risk
of shock, fire, or serious injury.
[] Make sure your extension
cord is in good condition.
When using an extension
cord, be sure to use one
heavy enough to carry the current your product
will draw. A wire gauge size (A.W.G.) of at least
14 is recommended
for an extension
cord 50 feet
or less in length. A cord exceeding
100 feet is not
recommended,
if in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
[] inspect for and remove all nails from lumber before
using this tool. Following this rule will reduce the risk
of serious personal injury.
[] If the power supply cord is damaged,
it must be
replaced only by the manufacturer or by an authorized
service center to avoid risk.
[] Save these instructions. Refer to them frequently
and use them to instruct others who may use this
tool. If you loan someone this tool, loan them these
instructions also.
A
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities
contains chemicals known to cause cancer, birth defects or other reproductive
harm. Some examples of these
chemicals are:
• lead from lead-based paints,
crystalline silica from bricks and cement and other masonry products, and
arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic
particles.
Advertisement
Table of Contents
