Craftsman 315.268192 Operator's Manual page 13

NOTCH
VACUUM ,_
ADAPTOR
1-I/4 in. VACUUMHOSE
WARNING: When sander is not connected to
vacuum, always install dust bag back on sander.
Failure to do so could cause sanding dust or foreign
objects to be thrown into the face or eyes which
could result in possible serious injury.
NOTE: A standard 1-1/4 in. vacuum hose fits inside the
smaller diameter hole inside the dust exhaust, while a
standard 2-1/2 in. vacuum hose connection fits inside the
larger hole of the dust exhaust.
LOCK=ON BUTTON
2-1/2 in. VACUUM HOSE
Fig. 8
ATTACHING THE VACUUM ADAPTOR
See Figure 8.
To attach the vacuum adaptor:
[] Unplug the sander.
[] Remove the dust bag from sander.
[] Align notch inside vacuum adaptor with raised rib
under dust exhaust.
[] Slide the vacuum adaptor over the dust exhaust until
adaptor clicks into place.
NOTE: The adaptor can be positioned with the dust
exhaust facing up, down, or away from the sander.
SWITCHTRIGGER
Fig. 9
SWITCH TRIGGER
See Figure 9.
[] To turn on the sander: Depress the switch trigger.
[] To turn off the sander: Release the switch trigger.
LOCK=ON BUTTON
See Figure 9.
The lock-on feature allows you to lock the switch trigger in
the ON position. Locking the switch trigger on allows you
to operate the sander for extended periods of time.
If you have the lock-on button engaged during use and
the sander is accidentally disconnected from the power
supply, disengage the lock-on feature immediately.
Also, do not lock the switch trigger if you might need to
suddenly stop the sander.
[] Depress the switch trigger.
[] Push in the lock-on button.
[] Release the switch trigger.
[] Release the lock-on button.
NOTE: To release the lock, depress the switch trigger.
13