Table of Contents
Advertisement
Yourdetail s ander hasbeenshipped completely
assembled. Inspect i t carefully to makesureno breakage
or damage hasoccurred duringshipping. I f anypartsare
damaged or missing, c ontact y ournearest S earsRetail
Storetoobtainreplacement partsbeforeattempting t o
operate sander.
,_
WARNING:
If any parts are missing, do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
_i
WARNING:
Your sander should never be connected to power supply when you are assembling parts, making
adjustments, assembling
or replacing sandpaper, cleaning, or when not in use. Disconnecting
your sander will
prevent accidental starting that could cause serious personal injury.
APPLICATIONS
(Use only for the purposes listed below)
•
Sanding on wood surfaces.
•
Removing rust from and sanding steel surfaces.
•
Polishing and buffing.
•
Scraping paint or glue from window panes.
INSTALLING
SANDPAPER
See Figure 2.
The rubber pad on your sander accepts pressure sensitive
adhesive backed sandpaper. Precut triangle shaped
sandpaper in assorted grits are available from your
nearest Sears Retail Store.
•
Unplug your sander.
,_
WARNING:
Failure to unplug your sander could
result in accidental starting causing possible serious
personal injury.
•
If installing sandpaper for the first time, proceed as
follows.
If replacing sandpaper, remove old sandpaper
by peeling it off rubber pad, then proceed as follows.
•
Carefully peel paper backing from new sandpaper.
•
Position sandpaper into place, then carefully press
sticky side of sandpaper on rubber pad.
Fig. 2
,_
WARNING:
Before connecting your sander to
power supply source, always check to be sure switch
is not in ON position. Failure to do so could result in
accidental starting of your sander resulting in
possible serious injury.
_
WARNING:
Do not allow familiarity with your
sander to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
,_
WARNING:
Never use your detail sander for wet
sanding or liquid polishing. Failure to comply can
result in electrical shock causing serious injury or
worse.
,_
WARNING:
The operation of any sander can result in foreign objects being thrown into your eyes, which can
result in severe eye damage. Before beginning power tool operation, always wear safety goggles or
safety glasses with side shields and a full face shield when needed. We recommend Wide Vision
Safety Mask for use over eyegrasses or standard safety glasses with side shields, available at Sears
Retail Stores.
Advertisement
Table of Contents
