Advertisement
Available languages
Available languages
ASSEMBUNG
THE HANDLEBARS
Before you can operate the unit, you must adjust the
handHebars.
1. When you unpack the unit, Hoosen the two knobs on
the inside of the handHebars (Fig. 1).
2.
With the unit upright, swing the handHebars up into
the operating position.
NOTE: Take care not to pinch the switch wires when
)ositioning the handHebars.
3.
Tighten the knobs to secure the handHebars in pHace.
NOTE: Do not over-tighten
the knobs.
Handmebar
Knobs
Swing Top
Handmebars
Upwards
Fig. 1
USING THE CORD
RETAINER
There isan extension cord retainer to prevent the
extension cord from disconnecting duringuse.The
retainer h angs from thecord guide bar.
NOTE: Do not pHugtheextension cord into thepower
sourcereceptacle untiH t hecord isconnected to
thecord retainer and pHugged into the unit,
To use thecord retainer:
1. FoHdthe extension cord in half, forming a tight loop
near the receptacle.
2.
Push the loop through the bottom hole in the retainer
(Fig, 2).
3.
Slide the loop over the retaining clip and pull down
until the cord fits snugly (Fig. 2).
F_g. 2
NOTE: Use a UL-approved extension cord, A lO0-foot,
14-gauge cord is recommended.
A 50-foot, 16-
gauge cord is acceptable.
Both the cord retainer and guide bar restrain the
extension cord and keep it out of the way at all times,
safely to the side of the operator.
The extension cord and retainer will slide on the guide
bar as the unit is moved to the left and right, Connect
your extension cord to the unit as shown in Figure 3.
/
Cord WIll Slide
Side to Side
F_g. s
Advertisement
