GE Monogram ZDBR240 Owner's Manual page 12

Care and Cleaning
Beverage Center
For blour
safetg
Unplug the beverage center before cleaning. If the unit is in a built-in location,
remove power at the circuit breaker.
Cleaning
the inside
Unplug the beverage center before
cleaning. If the unit is in a built-in location,
remove power at the circuit breaker. Use a
slightly damp cloth or sponge when cleaning
around switches, lights or controls.
Use warm water and baking soda solution-
about a tablespoon (15 ml) of baking soda to
a quart (1 liter) of water. This both cleans and
neutralizes odors. Thoroughly rinse and
wipe dry.
Other parts of the beverage center unit-
including the door gaskets, full extension
drawers and glass shelves-can be cleaned
the same wag.
Avoid cleaning cold glass shelves with hot
water because the extreme temperature
difference mag cause them to break. Handle
glass shelves carefullg. Rough handling of
tempered glass can cause it to shatter.
Drain hole
Periodically check the drain hole and
channel for any debris. If the drain is blocked,
condensation will not drain properly.
To check and clean the drain hole, remove
the bottom two glass shelves. Sweep a damp
cloth along the channel in the back of the
beverage center. Use a finger to sweep
away any debris from the drain hole.
Appearance mag varg
Drain hole
12