Operating Procedures; Power Source; Preparation For Embroidering - Brother BES-116 Instruction Manual
Electronic embroidery machine
Hide thumbs
Also See for BES-116:
- Supplementary manual (5 pages) ,
- User manual (3 pages) ,
- Supplement manual (3 pages)
Table of Contents
Advertisement
Chapter 6 Operation of Machine
1. Operating Procedures
1-1 Power Source
Power switch
1-2 Preparation for Embroidering
• Select embroidering data.
• Using the jog switches (
Note) An error message is displayed on the LCD if a pattern comes out of the hoop.
• Pressing
starts embroidering.
• After embroidering is finished, the machine is placed in the stand-by state.
112
Emergency stop switch
), determine a position to start embroidering.
BES-116AC
1. Turn the power on to the machine.
2. When the machine is equipped with the
shut-off switch unit, Reset the emergency
stop button.
3. When the machine is equipped with the
shut-off switch unit, Press the power
switch.
4. A message is displayed on the LCD.
• The alarm sounds three times and the
needle bar and the presser foot move
upward. Then the hoop moves to the zero
point and the sewing data screen is
displayed.
Note) When turning the power off and back it on
again, wait for at least 10 seconds.
Advertisement
Table of Contents
