Temp Read Command; Lamp Mode Read Command; Pc Type Read Command - Sanyo PLC-XF1000 - 12000 Lumens Manual

PLC-XF1000 Basic Serial Command Functional Specifications
7.7

Temp Read Command

COMMAND "CR6" [CR]
Get the temperature information inside projector
Detail With more than one temperature sensors installed in the projector, it is possible
to get all temperatures at once.
Acceptable
Response
Unacceptable
7.8

Lamp Mode Read Command

COMMAND "CR7" [CR]
Get current Lamp Mode in the multiple-lamp projector.
Detail
When there is any fail lamp, also can get the information about.
Acceptable
Response
Unacceptable
7.9

PC Type Read Command

COMMAND "CR9" [CR]
Detail Get the currently displayed PC Type
Acceptable
Response
Unacceptable
"%1＿%2＿%3" [CR]
%1 = temperature at Sensor 1
%2 = temperature at Sensor 2
%3 = temperature at Sensor 3
Temperature data is expressed as "00.0".
When the temperature goes under 0, the first character is "-" like
%1 "-05.5" [CR].
%2 When no temperature data returns due to hardware problems
the first character is "E" like" E00.0" [CR].
With more than one temperature sensors installed, the projector
returns the values in series.
Ex) "_31.5_ _35.2_ _33.4" [CR]
Each sensor data follows in sequence with one space between
each of them.
"?" [CR]
"%1" [CR]
ex: "0F"[CR]
The first digit indicates Lamp Mode.
0 = 2lamp Mode
1 = 1lamp Mode (Lamp No.1 used)
2 = 1lamp Mode (Lamp No.2 used)
The second digit indicates if the lamp is ON or OFF.
%1
Data is shown as "0-9" and "A-F", which is described in 4-bit
data. Assign each bit for each lamp data.
ex: 0 = ALL is OFF
1 = No.1 is ON, the other is OFF
2 = No.2 is ON, the other is OFF
3 = ALL is ON
"?" [CR]
"%1" [CR]
"Stand_by" ------------------------------------- Standby
"AV_Mode" ------------------------------------- AV Mode
%1 Current Table such as "UXGA1" ---------- PC Mode
"Go_PC_adj." --------------------------------- Auto
"No_signal" ------------------------------------ No signal
"?" [CR]
20/24