Air Filter - Hitachi CPRS55 - PERFORMA Home Theater Projector User Manual

Air filter
WARNING ►Do not replace the air filter during use or immediately after use.
Handling while the projector is in a high temperature could cause a burn and/or
malfunction to the projector. Before operating, make sure that the power switch is
off, that the power cord is not plugged in, and that the projector is cool adequately.
►Use only the air filter of the specified type. Do not use the projector with the
air filter and filter cover removed.
►Avoid wetting the projector or inserting liquids in the projector. It could result
in a fire, an electric shock, and/or malfunction to the projector.
CAUTION ►Please replace the air filter when it is damaged or too soiled,
and also when you replace the lamp.
When the indicators or a message prompts you to clean the air filter, clean the
air filter as soon as possible. If the air filter becomes clogged by dust or the like,
internal temperatures rise and the power may be automatically turned off for
malfunction prevention.
1.
Disconnect all the connectors and adapters that were connected to the
projector's ports. Then slowly turn the projector so that the lens-side is facing
up. Please be careful for a projector not to fall. While the projector is placed
lens-side up, hold the projector.
2.
Remove the filter cover and the air filter. Hold the knobs while pulling out it.
Usual filter cover
Filter cover for bottom-up use
3.
Apply a vacuum cleaner to the vent of the projector for the air filter. And then
slowly turn the projector bottom up.
Filter cover's
knobs
Filter cover's
knobs
Maintenance
Air filter's
knob
43