Advertisement
Method 1: Installing only this unit to the Electone
1
Electone
1
Insert but do not fully tighten one of the screws to the right front
screw hole under the Electone.
2
Hook this unit (with hole A, shown below) onto the installed screw.
A
3
Insert and partially fix
the remaining three
screws. Then, firmly
tighten all four screws.
4
Connect the USB cable to the USB TO DEVICE terminal.
For Japanese users only
5
Connecting USB storage devices
While holding this button, pull the unit toward you.
Method 2: Installing both this unit and the UD-FD01 floppy
disk drive to the Electone
2
None of the included screws are necessary in this method.
Both this unit and the floppy disk drive are installed by using the screws for the floppy disk drive.
1
Remove the floppy disk drive from the Electone (if the floppy disk drive
has already been installed.) The floppy disk drive can be removed by
reversing the order of the installation instructions described in the
Owner's Manual of the Electone.
Electone
2
Put this unit on top of the
floppy disk drive as shown.
Then, align the four holes of
these two units.
3
Temporarily install these
two units together with
screw A.
Insert and partially fix the
remaining three screws.
Then, firmly tighten all four
screws.
4
Follow step 4 in Method 1.
When connecting a USB storage device to the USB TO DEVICE, make sure that the connector
on the device is appropriate and that it is connected in the proper direction.
USB
USB TO DEVICE
During your performance, make sure to slide the USB unit under the keyboard. If you leave it in the
forward position, there is a danger of hitting it with your hand and breaking the USB device.
USB
USB
UD-FD01
Electone
Electone
A
JA
EN
ZH
Advertisement
