Craftsman 646.106591 Owner's Manual page 4

E
There is a cord lock feature on the handle
to prevent the extension cord from
detaching during use. Plug the cord into
the unit, then secure the cord as shown.
G
After flat surfaces are covered with wax,
do sides of the car. Hold the polisher as
shown. Let the cord hang free. It is not
necessary to use a criss-cross motion on
doors and fenders.
F
ALWAYS START AND STOP THE
POLISHER ON OR AGAINST THE CAR
SURFACE.
Place the extension cord over your
shoulder and do flat surfaces first---hood,
trunk and roof. Cover areas quickly with
broad, sweeping strokes in a criss-cross
pattern.
DO NOT press down on the polisher.
The machine's action, not pressure,
does the best job.
H
Remove the wax applicator bonnet and
use it to hand-polish all hard-to-reach
surfaces; under the bumpers, around the
door handles, etc.
Throw away the wax applicator bonnet
and put a clean terrycloth bonnet on the
polisher.
I
1;3!
---r'--
LEFT
'
RIGHT
I
.--.L-.
2'4
=::z::=
I
J
Polish the wax in the same order it was
applied. Use long, sweeping strokes in a
criss-cross pattern. Do not press hard. Let
the polisher do the work.
4