Advertisement
,_
WARNING:
Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
,_
WARNING:
Do not allow familiarity with your
drill to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
CHARGING
BATTERY
PACK
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it at least 3 hours prior
to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
•
Charge battery pack only with the charger
provided.
•
Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
•
Connect charger to battery pack by inserting
charger plug into input jack. As shown in Figure 1,
input jack is located on the back side of battery
pack.
•
Note: Battery pack can remain on your drill or be
removed while charging. When battery pack is out
of the drill, be careful not to touch both terminals
with a metal object. Touching both terminals with a
metal object will short out the battery pack,
•
Make sure charger plug and input jack are properly
connected.
•
Connect charger to power supply.
•
The charge,indicator
light (LED), located on the
battery pack, will light up and glow when the
charger is properly connected to power supply.
This light indicates the charger is operating
properly. It will remain on until charger is
disconnected from power supply. The light only
glows while your tool is charging, not during use.
•
After normal usage, 3 to 5 hours of charging time is
required to be fully charged.
•
The battery pack will become slightly warm to the touch
while charging. This is non'hal and does not indicate a
problem.
•
Do not operate the tool while it is connected to the
charger. The driving ability will not increase.
•
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
•
When batteries become fully charged, unplug
charger from power supply and disconnect it from
battery pack.
SWITCH
See Figure 2.
To turn your drit{ ON, depress the switch trigger. To
turn it OFF, release the switch trigger.
CENTERPOSITION
(LOCK)
SELECTOR
TRIGGER
Fig. 2
TWO SPEED
Your drill has a two speed feature in the switch.
Depress the switch trigger halfway for driving screws
at low speed. Depress the switch trigger all the way
for normal drilling. Release the switch trigger to turn
drill off,
SWITCH
LOCK
See Figure 2.
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use, To lock switch
trigger, place the direction of rotation selector in
center position,
,_
WARNING:
Battery tools are always in
operating condition. Therefore, switch should
always be locked when not in use or carrying at
your side.
Advertisement
