Check For Loose Fasteners - Weed Eater FL26 Instruction Manual

Trimming / .'_ _
above ground _ " _'_.
SCALPING - The scalping technique re-
moves unwanted vegetafiondown to the
ground Hold the bottom of the trimmer head
about 3 inches (8 cm) above the ground and
at an angle. Allow the tip ofthe line to strike the
ground around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
MOWING - Your trimmer is ideal for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
para}lel to the ground. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowin_
SWEEPING - The fanning action of the rotat-
ing line can be used for a quick and easy
clean up. Keep the line parallet to and above
the surfaces being swept and move the too_
from side to side.
Sweeping_
"-_-.g,,*=,al'_.; _ 't
4EIWAHNIBILi: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screws
• Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts
• STOP Switch - Ensure STOP switch func-
tions propedy by pushing and holding the
switch in the STOP position. Make sure en-
gine stops. Restart engine and continue
• Fuel Tank - Discontinue use of unit if fuel
tank shows signs of damage or leaks
• Debris Shietd - Discontinue use of unit if
debris shield is damaged
INSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
labels using a damp cloth w_h a mild deter-
gent.
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.
1. Clean the air filter cover and the area
around it to keep dirt from falting into the
carburetor chamber when the cover is
opened.
2 Open air filter cover by pushing button
(see ilIustraben). Remove air filter.
NOTE: To avoid creating a fire hazard or
producing harmful evaporative emissions, do
not clean fi{ter in gasoline or other flammable
solvent.
3 Wash the filter in soap and water.
4. AlIow fiIter to dry.
5. Replace air filter and close cover.
Button
Air Filter
Air Filter Cover
7