Maintenance - England's Stove Works 55-TRP22E Installation And Operation Manual

CAUTION: UNPLUG THE UNIT PRIOR TO ANY SERVICE WORK!
SEE EXPLODED DIAGRAM (ILLUSTRATION 4) FOR PARTS REFERENCE
Parts Orders: (800) 516-3636
NOTE: Visit our web site for downloadable maintenance sheets and/or a service video that details
and illustrates the following maintenance tasks.
WARNING: To perform any maintenance inside the rear of the unit, the stove must be out
(no fire), cooled down and unplugged. Electrical shock can occur if the unit is
not unplugged from power.
To remove the rear panel, simply loosen the eight (8) screws (size 5/16") and flex the panel.
The panel should come off without fully removing the screws.
Instructions for maintenance and part replacement procedures can be found on:
The Auger Motor and gearbox are one complete assembly (Part # PU-047040), and can be
removed by disconnecting the power leads and loosening the (
assembly. This bolt tightens down on the flat side of the gear shaft and locks the gear shaft and
auger shaft together – once the bolt is loosened, the entire assembly will slide from the locking
collar. There are two motor assemblies on the unit, and both rest on a shelf when not in operation.
When replacing a motor, the assembly should always be placed to rest on this shelf prior to starting
the unit.
The auger bearings (Part # PU-UCF204-12) are a sealed unit and do not require lubrication. To
replace the Top Auger, all the fuel must be removed from the hopper as well as from the Top Auger
assembly. Once this is done, the four bolts that hold in the bearing can be removed, followed by the
complete auger assembly. Loosen the two (2) set screws with a 1/8" allen wrench, which will
disconnect the bearing from the shaft (the bearing assembly and auger assembly can be replaced
by reversing this procedure). When placing the auger assemblies in the unit, always tighten the
four bolts in a diagonal pattern to ensure the bearings and shafts are aligned properly.
NOTE: Follow the same procedure to work on the bottom auger, with the exception that the pellets
do not have to be removed from the hopper.

MAINTENANCE

www.englanderstoves.com
Rear Panel Removal
www.englanderstoves.com
Auger Motors
Auger Bearings and Auger Shafts
14
Questions: (800) 245-6489
5
/ " head) set bolt in front of the
16