INTERIOR PREPARATION AND INSTALLATION OF THE BACK OF THE UNIT
Housewarmer recommends the use of the wall template to properly cut the wall holes and place the heater. If the template is
4
damaged or not included, refer to the table and graphic below for proper alignment of the wall holes and heater.. Be sure the
baseboard does not get in the way.
5
MARKING FOR
WALL MOUNTING
PLATE HOLES
FLOOR LINE
Page 18
MARKING FOR
WALL HOLE
MARKING FOR
GAS INLET HOLE
Model
HWDV080(B)DV
C
D
E
F
G
I
Remove the template from the wall after the holes are marked.
The hole location markings will be present on the wall.
MEASUREMENTS
HWDV181(B)DV
7 3/8"
11 3/8"
10 7/8"
10 7/8"
21"
24 1/2"
9 1/4"
9 1/4"
4"
4"
6 1/4"
6 1/4"
24632-0-0508