Advertisement
MODEL
WFF81-C
OPTIONAL FAN KIT
INSTALLATION
INSTRUCTIONS
NOTE:
This fm_ kit is to be installed after installation
of wall furnace
and with the wall furnace
front panel in
place.
STEP 1.
This appliance, when installed, must be electrically grounded in accordance with local codes, or in
the absence of local codes, with the latest edition of the National Electric Code, ANSI/NFPA
No. 70. In Canada, see the current Canadian Electrical Code CSA C22.1.
STEP 2.
STEP 3.
STEP 4.
STEP 5.
Set fan kit on top of the wall furnace front panel. Using the back top edge of the fan kit cabinet
as a _uide, mark a horizontal line across the wall. Mark a small vertical line which aligns with the
slot mcated toward the rear of the fan kit casing.
Using the four one inch screws provided, secure the wall mounting bracket to wall 1/8" below the
horizontal line. Fan attachment
bracket must be up and threaded nut sert aligned with the small
vertical line. Note: Anchors (not provided) may be required.
Remove junction box and connect 115v power supply in accordance with the wiring diagram.
Replace j unction box.
Set fan kit on top of wall furnace front panel. Slot should align with the nut sert. Secure fan kit
to wall mounting
bracket with thumb screw provided.
Thumb
Screw
Wiring
Threaded
Nut
Slot
Diagram _,
Sert
_'-----.
i
Fan Attachment
Bracket
WM1Mounting
Bracket
One Inch J
Screw (4)
_"
Junction
Box
Wall Furnace
Front Panel
Page l3
Advertisement
