Unpacking The Packing List; Assemble The Face - Century OM-117071002 Operator's Manual

The following procedures describe the
process required to assemble, install,
maintain, and prepare to weld with your
new wire feed 80 amp ac welder•
UNPACKING THE WELDER
1. Remove any cartons or bags
containing parts/accessories.
2. Open the cartons or bags packed
with your welder and inspect their
contents for damage• Report any
missing or damaged items
immediately•
3. Layout the parts and compare them
to the illustrations in Figure 1 and
the packing list in Table 1 to
familiarize yourself with the parts
and what they are called• This will
help you when reading the manual•
4. Grasp the top handle of the welder
and lift the welder out of the carton•
Welding Wire
PACKING LIST
Table 1 contains a list of the items you
will find packed in the carton•
Table 1. Packing List
PART NO. ITEM QTY.
Welder 1
332-239-000 Face Shield 1
Face Shield Handle 1
Handle Screws 3
Shaded Lens 1
Clear Lens 1
930-405-000 Parts Bag 1
334-160-000 Contact Tip, 0.030 2
334-203-000 Nozzle 1
331-469-001 Wire .030 Fluxcore (1/2#)
804-502-000 Card, Registration 1
811-597-000 Manual, Instruction 1
Weld Gun Nozzle
Face Shield
Contact Tip
Figure 1. Welder Parts/Accessories
ASSEMBLE THE FACE
SHIELD
•
.
Press one of the lens retainer tabs
(located in the rectangular lens
cavity inside the face shield) toward
the center of the lens cavity and lift
the retainer out of the cavity (may
require the use of a straight blade
screw driver to pry the tab).
Insert the clear plastic lens then the
shaded lens into the rectangular
lens cavity in the face shield• The
lenses are put in from the inside
and the clear lens goes in first to
protect the shaded lens. Insert the
lens retainer in place behind the
shaded lens and snap the tabs into
the holding slots at the ends of the
lens cavity to secure the lenses in
place•
8