The Timer; Cleaning Lock - Bosch NIT8665UC Use And Care Manual

The timer
It is programmed as
follows
Once the time has elapsed
Correcting the time
Switching the timer off
Recommendations and
warnings
This can be used to time periods up to 99 minutes. It is independent of the other
settings.
1. Press the Timer symbol. ,'_q,'_q appears in the time programming function display.
The __., min and _ indicators light up.
2. Set the required time using symbols 1 to 9.
After a few seconds, the __
count down.
indicator goes out and the programmed time starts to
A beep sounds. ,'_qO a nd _ also appear in the time program function display. Press
the Timer symbol. The indicators go out and the warning beep stops.
Press the Timer symbol. The __
symbols 1 to 9.
and _ indicators light up. Change the time using
Press the Timer symbol. The __ and _ indicators light up. Then press the 0
symbol until ,_._,'-"_ appears on the time program function display. The _ indicator goes
out.
If the set time is not displayed, press the Timer symbol several times until the
indicator lights up on the time program function display. To program a cooking time
of less than 10 minutes, always press 0 before selecting the required value. The
timer will be deactivated after a power outage. The element automatic OFF function
and the timer function can both be operated simultaneously.
Cleaning lock
Note
Cleaning the control panel while the cooktop is on may change the settings.
To avoid this, the cooktop has a control panel pause function.
Press the Clean lock symbol until the _ indicator appears. The control panel is
locked for approximately 35 seconds.
The surface of the control panel can now be cleaned without risk of changing the
settings.
After the time has elapsed, a warning beep will sound and the function is
deactivated. The control panel lock has been deactivated.
This block does not affect the Clean lock symbol or the main switch. The control
panel pause function can be deactivated and the cooktop can be switched off at
any time.
25