Advertisement
For Interior Model
(Case 1)
"_ Connecting
to water supply line
- Shut off the main water supply line and turn the Ice maker to
the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions
in the ice maker installation kit.
1. Cold Water
line
2. Pipe Clamp.
3.Copper
(or Plastic)
line
4.Compression
Nut
&Compression
Sleeve
6.Shut
Off Valve
7.Packing
Nut.
6
5 4
Connect
the water line to the refrigerator
Slip the compression
nut and plastic ferrule
through the plastic tube.
After inserting the sleeve, tighten the compres-
sion nut onto 1/4" compression
fitting(union).
@
Do n0t0vertighten thec0mPressi0 n
NOTE
nut.....................
- Slip the compression
ferrule and nut on cop-
per (or plastic) tubing as shown.
Tighten the comperssion
nut onto the com-
pression
fitting(union).
- Turn water on and check for any leakege.
|
/'_CompressionaUtFerrule
.'
Sleeve
/
Compression
fitting
_
,"; Ferrule
Compression
Nut
",,
_.o°°"
Waterline must be connected to drinkable water only
NOTE
(Case 2)
":< Check the water supply line
\'7
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler "A" to the tap.
- Every join should be protected with sealing tape.
The water line must be connect-
ed to the cold water piRe.
I
If it is connected
to the hot
I
water pipe, it may cause the puri- I
tier to malfunction.
J
COUPLER"A"
If the c0uple r does not fit on th e curren t tap, go
th e nearest
auth0rised
service dealer and purchase
the right couplers
fittings,
TAP
28
Advertisement
