Starting Instructions; Stopping Instructions - Bolens BL150 Operator's Manual

WARNING: Operate
this unit only in a
well- ventilated outdoor
area. Carbon monoxide exhaust fumes can be lethal in
a confined area.
WARNING:
Avoid accidental starting.
Make sure you are in the
starting position when pulling the starter rope (Fig. 8).
To avoid serious injury, the operator and unit must be
in a stable position while starting.
STARTING INSTRUCTIONS
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. See
Oil and Fuel Mixing Instructions.
Make sure the On/Off Stop Control in the ON ( I )
position (Fig. 6).
Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in the
primer bulb and fuel lines (Fig. 7). If you can't see fuel in
the bulb, press and release the bulb as many times as it
takes before you can see fuel in it.
4. Place the blue choke lever in Position 1 (Fig. 7).
5. Crouch in the starting position (Fig. 8) and squeeze the
throttle control. Pull the starter rope briskly 5 times.
NOTE: The unit uses EZ-Pull Version
3
TM,
which significantly
reduces the effort required to start the engine.
6. Place the blue choke lever in Position 2.
2 =
7. While squeezing the throttle control, pull the starter
rope briskly until the engine starts.
8. Keep the throttle squeezed and allow the engine to
warm up for 15 to 30 seconds.
9. Place the blue choke lever in Position 3. The unit is
ready for use.
IF... The engine does not start, go back to step 3.
IF... The engine fails to start after a few attempts, place
the blue choke lever in Position 3 and squeeze the
throttle control. Pull the starter rope briskly 3 to 8
times. The engine should start. If not, repeat.
IF WARM... If the engine is already warm, make sure the
On/Off Stop control is in the ON position and start the
unit with the blue choke lever in Position 2. After the
unit starts, move the blue choke lever to Position 3.
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control. Allow the
engine to cool clown by idling.
2. Press and hold On/Off Stop Control in the OFF (O)
position until engine comes to a complete stop.
Fig. 6
On/Off Stop
Control
Start/On (I)
Position 1
Position 2
Position 3
Blue Choke
Lever
Primer Bulb
Fig. 7
Starting Position
Starter Rope
\
Throttle Control
Fig. 8