Ariston AW120 Instructions For Installation And Use Manual page 6

Installation
m m
lne arrives
Whether new or just transported to a new house, installation is extremely important
{'or the correct functioning of"your washing machine.
After removing the appliance from its packaging, check that it
is intact, The inside of the machine is supported, for
transportation, by four eNpping bolts on the back panel.
Before using the waeNng machine,
remove the 4 external shipping
remove the spacers together
with the rubber tubes attached to them
(save all the parts) and use the plastic
blanking plugs provided to fill in the
hobs, Use the wrench provided to
remove the external bolts,
Attach the two rubber hoses provided to the red (hot) and
white (cold) water inlets on the back (top right) of the appliance,
Using the "U"-Connector provided, place the drain hose into
the drain pipe (or the sink,) See Plumbing on Page 7 for more
details,
Leveling
The washing machine must be levelled appropriately in order to
guarantee its correct functioning, To level the appliance, the front
feet must be adjusted; 1heangb of inclination,measured according
to the worktop, must not exceed 2°,
WARNING
Excessive Weight Hazard
Use two or more people to move
and install your appliance,
Failure to do so can result in
back or other injury
The _ront feet are se//.-/ock/r(_ & ac_bstab/e
For your own protection, and to prevent accidents,
injury
and fire,
please
read the following carefully:
1. Destroy the carton and plastic bags, after the washing
machine has been unpacked,
2. Child ren should never be left None or unattended in the area
where appliances are located,
3. Washer installation and grounding must be done in
accordance with local codes by a qualified installer, Installation
instructions are packed in new washer for the installer's
reference,
4. ONLY Low Sudsing detergent is recommended for this
appliance,
5. The washer must be
plugged into a properly
grounded 8-prong
electrical outlet, For
your safety, the third or
must never be
removed,
DO NOT USE AN
EXTENSION CORD.
6. Repair or replace-
ment of a part should
be made only by a
qualified service
technician to prevent personal injury or damage to the machine,
7. Disconnect power to the washer at the circuit breaker or
fuse box, or unplug the machine in an emergency when
servicing is required, Have the installer show the proper switch
or fuse at the electrical disconnect box,
EmectricN Requirements
EtectricN Shock Hazard (death, fire or ebctricN shock};."
1) PJug into a grounded 3 prong outlet.
2) Do not remove ground prong.
3) Do not use an adapter or an extension cord.
4) The AppJiance shouJd be connected to an lndividuN
Branch Circuit with N. 14 AWG Wire and Protected by 15
A Fuse.
GROUNDING INSTRUCTIONS
by providing a path of bast resistance for electric current, This
appliance is equipped with a cord having an equipment-
grounding conductor and grounding plug, The plug must be
plugged into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances,
WARNING _improper connection of the equipment-grounding
conductor can result in a risk of electric shock, Check a qualified
electrician if you are in doubt as to whether the appliance is
Do not modify the plug provided with the appliance, if it wiii nol
fit the outlet, have a proper outlet installed by a qualified
electrician,
6 lnstructionsforinstallationanduse www.a detonapplia rices.us