Cleaning Filters - Ariston AW120 Instructions For Installation And Use Manual

The washing
machine does not
drain or spin.
Does the selected program
incorporate water drai-
ning? Some programs stop
at the end of the wash cycle
and draining will have to be
selected manually.
@ _sthe "Easy iron" function
-where provided - enabled?
This function requires
manual selection for
draining.
_sthe drain pump dogged?
To check it, turn off the water
supply, unplug the washer-
dryer and follow the
instructions on page 18, or
caII technicaI support.
_@ls the drain hose kinked?
The drain hose must be as
straight as possible. Make
sure the drain hose is not
crimped or kinked.
_J_e the washing machine's
drain hose clogged? Is
there an extension of the
drain hose? If so, is it
positioned incorrectly,
blocking the water flow?
¢
Excessive vibration
during the spin cycle.
_Have aH shipping bolts
been removed during
installation? See the
following page on
installation procedures.
_Has the washing machine
been meveHed correctBy?
The levelling of the
appliance should be
checked periodically. Adjust
the feet and check them with
_ _ethere space between the
machine and adjacent
units? If it is not a buNt-in
model, the washing machine
wilI oscillate a bit during the
spin cycle. An inch or two of
space should therefore be
left around it.
The washirLq
machine _ea_s.
_ _ethe metaB ring of the inBet
hose propermy attached?
Turn off the water supply,
unphJg the appliance and try
tightening its attachment
without forcing it.
_ _e the detergent dispenser
obstructed? Remove and
wash it under tap water.
_e the drain hose well
attached? Turn off the water
supply, unplug the
appliance and try tightening
its attachment.
Too much foam.
_ Is the detergent appropriate
for washing machine?
Check whether the definition
on its label reads "for machine
wash" or "hand and machine
wash", or any other similar
wording.
_ _athe correct amount being
used? An excessive amount of
detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling inthe
internal parts of the appliance.
.if, despite alI checks, the
washer-dryer fails to function
and the problem persists, call
your nearest authorized
Customer Service Centre,
1-888-426-0825 providing
the folIowing information:
- the nature of malfunction
- the modeBtype no. (MOdooo°°)
- the seriam number (S/N °.oo}
This information can be found
on the data plate situated at the
back of the washer-dryer.
Remove filters
using tweezers,
clean and replace
Cleaning Filters
Drain: to avoid flooding
be careful to the adjust the drain
hose to at least
25" above the base
of the appliance.
Fasten the hoses securely.
m
J
www.aristonappliances.us lnstructionsforinstallationanduse 17