Ariens A160H22 (96146000 Owner's Manual page 18

TROUBLESHOOTING - See appropriate section in manual unless directed
to a qualified service center.
PROBLEM
Poor cut -
uneven
Excessive
vibration
Starter rope
hard to pull
Grass catcher
not filling
(If so equipped)
Hard to push
Loss of drive
or slowing of
drive speed
CAUSE
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, Jeaves
and trash under mower.
1. Worn, bent or loose blade,
2. Bent engine crankshaft.
1.
Engine flywheel brake ison
when control bar is released.
2, Bent engine crankshaft,
3. Blade adapter broken.
4. Blade dragging in grass,
1. Cutting height too low.
2. Lift on blade worn off.
3. Catcher not venting air.
1. Grass is too high or wheel
height is too low.
2. Rear of lawn mower
housing or cutting blade
dragging in grass,
3. Grass catcher too full.
4, Handle height position not
right for you.
1. Belt wear.
2. Belt off of pulley.
3. Drive cable worn or broken,
4. "Loose" drive control system.
CORRECTION
1. Replace blade, Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Reptace blade. Tighten
blade bolt,
2, Contact a qualified service
center.
1, Depress control bar to
upper handle before
pulling starter rope.
2. Contact a qualified service
center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
I. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2, Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to suit,
1. Check/replace drive belt.
2, Check/reinstall drive belt.
3. Replace drive cable,
4. Adjust drive control.
I8