Subscribe to Our Youtube Channel
Related Manuals for Meinberg USB 5131
Summary of Contents for Meinberg USB 5131
-
Page 1: Operating Instructions
Technical Information Operating Instructions USB 5131 Driver Software for Windows 2000/XP/Vista Operating Systems... -
Page 2: Impressum
Impressum Meinberg Funkuhren GmbH & Co. KG Lange Wand 9 D-31812 Bad Pyrmont Phone: ++49 52 81 - 9309-0 Fax: ++49 52 81 - 9309-30 Internet: http://www.meinberg.de Email: info@meinberg.de September 26, 2007... -
Page 3: Table Of Contents
Inhaltsübersicht Impressum .................... 2 General information about DCF77 ............5 Overview USB5131 ................6 Installation .................... 7 Power Supply ................7 Aligning the antenna ..............7 Status LEDs ................7 Technical Specifications ............... 8 Physical Dimensions ..............9 CE Label ..................9 Content of the diskette ................ -
Page 5: General Information About Dcf77
General information about DCF77 The radio clocks made by Meinberg receive the signal from the long wave transmitter DCF77. This long wave transmitter installed in Mainflingen near Frankfurt/Germany transmits the reference time of the Federal Republic of Germany. This time reference is either the Central European Time (Mitteleuropäische Zeit, MEZ) or the Central Euro-... -
Page 6: Overview Usb5131
USB5131. Driver software for other operating systems can be found on the Meinberg homepage for download: http://www.meinberg.de/english/sw/index.htm Front... -
Page 7: Installation
Installation Power Supply The USB5131 is powered via the PC’s USB port. After connecting the USB port the radio clock is ready to operate. For proper operation it is essential to pay attention to the following points. Aligning the antenna Generally, the exact alignment of the USB5131 module with its internal antenna is important. -
Page 8: Technical Specifications
Technical Specifications RECEIVER: narrowband straight receiver with automatic gain control bandwidth: approx. 40Hz reception via internal or external ferrite antenna MODULATION: demodulated time marks indicated by LED TIMECODE CHECK: Multiple software check of the incoming timecode Parity and consistency check over a period of two minutes FREE RUNNING: Without RF signal the clock runs on XTAL with an accuracy of 10 (after 24h of synchronous operation) -
Page 9: Physical Dimensions
Physical Dimensions Plastic housing, IP30 protected, 73mm x 117mm x 24mm (width x depth x height) CE Label This device conforms to the directive 89/336/EWG on the approximation of the laws of the Member States of the European Community relating to electromagnetc compatibility. -
Page 10: Content Of The Diskette
If the present delivered diskette doesn’t include a driver program for the operating system used, it can be downloaded from: http://www.meinberg.de/english/sw/ On the diskette there is a file called „readme.txt“, which helps installing the driver correctly.
Need help?
Do you have a question about the USB 5131 and is the answer not in the manual?
Questions and answers