Hitachi CP-X4021N Network Manual page 19

1.5 Selecting the network connection method (continued)
If you put a check mark in the box "Not displaying confirmation dialog for adding
Network settings", the projector memorizes current configuration and this dialog
is not displayed again. To display this dialog again, click Option
"LiveViewer" main menu and remove the check mark in the box "Not displaying
confirmation dialog for adding Network settings".
If you want to change the Network
configuration to add, click the [Change]. A
dialog for changing the Network configuration
as shown to the right will be displayed. Enter
IP address and subnet mask , then click the
[OK]. Procedure to connect to the projector
will start.
Proceed to item 1.8 Confirming the
connection to your destination. (
If you click the [Cancel], you will return to the
dialog for adding a Network configuration.
If the entered IP address and projector's IP
address are the same, a warning dialog shown
to the right will be displayed.
Click the [OK], and then enter a different IP
address from the projector's one in the dialog
for changing Network configuration.
If the connection is not available with the
entered Network configuration, a warning
dialog shown to the right will be displayed.
Click the [OK] to return to the dialog for
changing the Network configuration, and then
enter appropriate configuration.
NOTE • If a Network configuration to connect to the projector has been added
on the computer, the added Network configuration will be erased once the
application software is closed.
1. Connection to the network
30)
icon in the
19