- Enter Burn-In Mode
* Cycle setting is based on the defect symptoms. ie: If it is NFF, the run-in time is 4 hours.
You have to set the lamp on for 50min. and lamp off for 10 min for 4 cycles.
Press power > left > left > menu
Choose Burn-In Test > enter
Lamp On (Min)
Lamp Off (Min)
Set burn in cycle
After setting up the time, choose Burn-In mode and hit enter
Screen Defects (While replacing DMD Chip, DMD BD and MB)
< Figure: Zone A & B Definition >
Confidential
Press right key to adjust the time (50)
Press right key to adjust the time (10)
Press right key to adjust the cycle
4-3
P5270/P5270 Refresh