Installation - GE JBP80 Use And Care & Installation Manual

.... _ i>_ _iII i _i LI_ _ i _i i :i!
INSTALLATION STRUCTIONS
BEFOREYOU BEGIN
Read these instructions completely
and careflflly.
IMPORTANT: Save these instructions lor
the local electrical inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING
CODES AND ORDINANCES.
NOTE TO INSTALLER: Leave these
instructions with the appliance after
installation is completed.
NOTE TO CONSUMER: Keep this Use and
Care Guide and Installation Instructions lot
fllture use.
NOTE: This appliance must be properly
grounded.
TOOLS¥01/WILL NEED
,Large blade screwdriver
• Channel lock pliers or small ratchet wrench
with 3/16" socket (for leveling range)
1/4" hex head nutdriver
ELECTRICAL REQUIREMENTS
CAUTION, FOR PERSONAL SAFETY:
DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.
REMOVE HOUSE FUSE OR OPEN
CIRCUIT BREAKER BEFORE BEGINNING
INSTALLATION.
This appliance must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or time delay fuse, as
noted on the rating plate.
Wiring must conform to National Electric Codes.
If the electric service provided does not meet the
above specifications, it is recommended that a
licensed electrician install an approved outlet.
Because range terminals are not accessible
after
range is in position, flexible service conduit or cord
must be used.
STEP 1
PREPARETHE OPENING
1%" spacing is recolmnended from the range to
adjacent vertical walls above cooktop surface.
Allow 3o" minimum clearance between surface
units and bottom of unprotected wood or metal
top cabinet, and t5"
nfinimum between
countertop and adjacent cabinet bottom.
EXCEPTION: Installation of a listed microwave
oven or cooking appliance over the cooktop shall
conform to the installation instructions packed
with that appliance.
Toeliminate the risk of burns or fire by reaching
over heated surface units, cabinet storage space
above the surface units should be avoided. If
cabinet storage is to be provided, the risk can be
reduced by installing a range hood mat proiects
horizontally a min. of 5 beyond the bottom of
the cabinets. Make sure the wall coverings,
countertops and cabinets around the range can
withstand heat generated by the range, oven or
cooktop
up to 2000 E
NOT LESS THAN
WIDTH OF RANGE
J
ooo
i-
M)N, 115g"
I "
I
'
1 OUTLET B OX
| ___.r_________________/WITHIN EITHER
WALL
I
SHADED AREA
iNSTALL , _,
OUTLET BOX WALL _ _'
ON EITHER ,,, ¢ OF RANGE I
SIDE OF _ '"k. t_ 77/' J_ 'F--___. /
OUTLET I_IIZ .... _
T' _1_'-'74,,_,,1
1_14%"_._,
Anti-Tip Bracket _--_ = ""
(install in either rear corner}
(contit_ued next page)
49