Epson Photo 900 Installation Instructions Manual
Epson Photo 900 Installation Instructions Manual

Epson Photo 900 Installation Instructions Manual

Mis continuous flow for epson photo 900
Hide thumbs Also See for Photo 900:

Advertisement

Quick Links

What you will need to Install the Photo 900 CFS

Complete CFS-900P Kit
Scissors
Measuring Tape or Ruler
Marking Pen or Pencil
Paper Towels
Alcohol or Cleaning Solution

What is included in your Photo 900 CFS Kit

Cartridge Set with tubes attached
Set of 6 Inks (C, Lc, M, Lm, Y, K)
6 Drilled Bottle Caps
Clear Plastic Bridge Bracket with Black Velcro
Clear Plastic Tube Support with White Adhesive Backing
1 Beige Tube Clip
6 Black Velcro Circles (Hook & Loop)
1 Piece of Loop Velcro ¾ x ¾
2 thin tie wraps.
MIS Continuous Flow for Epson Photo 900

Installation Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Photo 900 and is the answer not in the manual?

Questions and answers

Summary of Contents for Epson Photo 900

  • Page 1: Installation Instructions

    MIS Continuous Flow for Epson Photo 900 Installation Instructions What you will need to Install the Photo 900 CFS • Complete CFS-900P Kit • Scissors • Measuring Tape or Ruler • Marking Pen or Pencil • Paper Towels • Alcohol or Cleaning Solution What is included in your Photo 900 CFS Kit •...
  • Page 2 If you have a brand new printer, follow the Epson instructions for setting up your printer. Use the Epson cartridges that came with the printer. Follow normal installation instructions for the software. Test the printer by printing pictures. Learn how to use the Epson utilities to run a Nozzle pattern check and to run a Cleaning Cycle.
  • Page 3 Bracket. Do not separate the Hook and Loop, Keep them together just like they were when delivered. Remove the adhesive backing from the Hook portion of the Velcro. Keep it attached to the Loop portion. Carefully install the Bridge Bracket in its proper location at the left edge of the housing, as shown above. Keep it straight and press down firmly all along the edges.
  • Page 4 Step 6 – Install Cartridges Use a flat blade screwdriver and remove the Epson cartridge hold down clamps, black and color. Insert the screwdriver blade at the hinge point and twist. The clamps will come right off, without any damage.
  • Page 5 Insert the tubing into the tube clip and close it until it snaps shut. Don’t pinch any of the tubes. Next, separate the tubes, or un-web them, so that they are separated all the way back to the beige tube clip you just installed.
  • Page 6 Velcro attaches bottles to printer (This is photo from a 2200 printer) Hold the tube against the outside of the ink bottle. Cut off the excess tube at a 45 degree angle. Insert the tube into the bottle. Make sure that you insert 3 ½ to 4 inches of tube length into the center hole in the bottle cap.
  • Page 7 After the cleaning cycle is over, bring up an image on your favorite graphics program and get set to make a print. Be sure to put paper in the printer. Before printing, use the printer properties and Epson utilities to check the nozzles. The nozzle pattern may not be perfect at this point.

Table of Contents