Bosch SHX36L Use And Care Manual page 10

"4.Check,,'Clean the SprayArm
Nozzles
Occasionally check thespray arms to
ensure t hatthespray nozzles are
unobstructed. You must r emove t hespray
arms tocheck them forobstruction.
- Toremovethe top sprayarm:
a) Remove the empty top rack from the
dishwasher.
b) Turn the rack upside-down. The top
spray arm is held in position by a locking
nut as shown in Figure 17A. Turn the
!ocking nut counter-clockwise 1/8 turn and
remove it, as shown in Figure 17B to
release the spray arm.
Figu re 17
c) Remove the spray arm as shown in
Figure 18.
Figu re 18
d) Look for obstruction in the spray
nozzles.
e) If the spray nozzles need cleaning,
flush them under running water.
CARE AND MNNTENANCE
- To reinstall the top spray arm:
t) Return the top spray arm to its
installed position.
d) Return the locking nut to its
installed position and turn it 1/8 turn
clockwise.
h) Return the top rack to the top rack
roller guides.
- To remove the bottom spray arm:
1) Remove the empty bottom rack from
the dishwasher tub.
j) Grasp and lift the bottom spray arm
as shown in Figure 19.
Figure 19
k) Look for obstruction in the spray
nozzles.
/) If the spray nozzles need cleaning,
flush them under running water.
- To reinstall the bottom spray arm:
rn) Return the bottom spray arm to its
installed position and press it so that it
snaps into place,
n) Return the bottom rack to its
installed position.
5. Check/Clean the Filter System
Your Bosch dishwashers has a filter
system that is made up of a Large Object
Trap/CyIinder Filter assembly and a Fine
Filter. The filter system is located on the
dishwasher floor and is easily
accessible.
During normal use the filter system is
self-cleaning, but you should
occasionally inspect it for foreign obiects
and clean it when necessary.
- To Remove the Large Object
Trap/Cylinder FHter Assembly:
a) Remove the bottom rack.
b) Grasp the assembly as shown in
Figure 20, and turn it counter-clockwise
1/4 turn.
Figure 20
c) Lift out the assembly as shown m
Figure 21.
Figure 21
d) Carefully examine the assembly. If
you find debris in the Large Object Trap,
turn it upside-down and gently tap it on
a surface such as a countertop to
dislodge and remove the debris. Flush
the Cylinder Filter clean by holding it
under running water.
- To Remove the Fine FHter:
e) Lift the Fine Filter from the
dishwasher floor as shown in Figure 22
and flush it clean by holding it under
running water.
Figure 22
9