Sears Kenmore SR10251 Use, Care, Safety Manual page 17

BUMP
IN RACK
GUIDE
Do not touch hot oven bulb. Do not
touch bulb with wet hands. Hever
wipe oven light area with wet cloth,
Hever touch the electrically live metal
collar on the bulb when replacing.
BULB SOCKET
Be careful not to scratch the oven finish when installing
or removing oven racks.
To instalh
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bit and push the
rack all the way In,
To remove=
1o Pull the oven rack out, then up, in one motion, See
the cleaning chart.
NOTE:
(A) The racks are designed with stop locks. When
placed correctly on the rack support and extended from
the oven, the stop lock prevents the racks from tilting
when you are removing food from the racks or placing
food on them,
(B) For best performance, remove oven racks during
self-clean cycle. If oven racks are left inthe range during
a clean cycle, they will darken, lose their luster and
become hard to slide. If you choose to leave the racks
in the oven, you can polish the edges of the racks with
steel wool and apply a small amount of vegetable oil to
the rack edges after the self-clean cycle. This will make
the racks easier to sltde.
BULB COVER BAIL WIRE
To remove:
1_ Disconnect electric power to the oven at the main
fuse or circuit breaker.
2, Hold your hand under cover and firmly push back the
bait wire until it clears the cover, The cover will fall
into your hand. DO NOT REMOVE ANY SCREWS
TO REMOVE THE COVER.
3. Replace bulb with 40-watt home appliance bulb,
To replace cover:
1o Place cover into groove of lamp receptacle. Pull were
bail forward until it snaps into place. Be certain wire
bail is tn center of cover, WEre will hold cover firmly
when in correct position,
2 Connect power to oven.
16 NEMNT130